![]() • 15935 Answers SOURCE: The steps involved can vary slightly depending on your furnace model and pilot valve type, so if possible try and find the instructions inside the furnace door cover or in the instruction manual. This is for a gas fired furnace, but applies to any gas-fueled appliance including water heater. Two of the most common types of pilot valve body assemblies either have a red reset button and a gas valve or no reset button and a valve knob that can be depressed. But whichever type you've got, if you have an older model furnace with a standing pilot (flame is lit all the time) then this is the basic procedure. • Turn you thermostat to 80 degrees or to a setting that will demand heat. Cuddeback Model F2 ManualMake sure the thermostat is in 'Heat' mode. https://kindlorlando127.weebly.com/blog/visual-basic-for-win7-64bit-torrent. • Go to the furnace and find the pilot valve. The pilot valve body is a box shaped device into which the main gas line will run and is located near the gas burners. It will usually have a gas **** or valve knob that reads 'On, 'Pilot' and 'Off.' Locate this gas **** or knob. • Turn the knob or gas **** to the 'Off' position and wait about 3 minutes for any residual gas to clear away. • Find the pilot. It's located near the gas burner tube assembly in the furnace. • Get your match or lighter ready. Find out how efficient your Potterton Myson British Gas 50F2 Gas boiler is and get costs for new installations, repairs and servicing. Sometimes the pilot is hard to reach. If possible, try and use a long fireplace match when you light it. If you don't have a fireplace match then a butane BBQ grill lighter works well too. Collins 516-f2 ManualIf you don't have that, then you can fasten a match to the end of a stick when you light the pilot • If you have a pilot with a red Reset button, turn the gas valve from 'Off,' to 'Pilot.' • If you have a pilot with no red button, turn the knob from 'Off' to 'Pilot.' • Place the lit match or ignited lighter tip at the pilot and depress and hold the button or depress the knob as appropriate. Depress the button or knob for about 30 seconds. Panasonic Dmc-f2 ManualThis maintains gas flow to the pilot until the thermocouple gets hot enough to open the main gas valve. • Once the pilot stays lit, slowly release the button or knob and turn the gas **** or knob from the 'Pilot' position to the 'On' position. This will ignite the burners and keep the flow of gas supplied as required for the burners as called for by the thermostat. • If the burners fail to ignite then it may be because the thermocouple did not get hot enough to open the gas valve. Wait a few minutes and then repeat the above procedure.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |